Can a power station run a pellet stove?
Yes, a typical pellet stove draws about 150 W once running (auger, blower and control board) and 300 to 400 W for a few minutes while the igniter lights the pellets. A 2 kWh station gives roughly 11 hours; check the label on yours, and keep the exhaust and carbon monoxide alarm working.
Typical numbers
| Item | Typical running | Typical start-up draw | 1 hour |
|---|---|---|---|
| Pellet stove, 120 V | about 150 W (auger, fans, controls) | about 400 W while the igniter heats, a few minutes | about 150 Wh |
Typical values: small stoves on low can draw about 100 W, large ones on high about 200 W. The label or manual gives watts or amps; amps × 120 V is watts.
Worked example
150 W × 1 h = 150 Wh for each hour burning. With 85% of rated capacity usable:
| Battery rating | Usable | Hours burning |
|---|---|---|
| 1,000 Wh | 850 Wh | about 5.7 hours |
| 2,000 Wh | 1,700 Wh | about 11 hours |
| 3,000 Wh | 2,550 Wh | about 17 hours |
Good to know
- Many stoves are hardwired or have an exhaust blower that must keep running. If power drops mid-burn, some stoves shut down and may need a relight, which uses the igniter again. Check your manual before relying on a battery.
- Do not run a stove with a dead exhaust fan. Keep a working carbon monoxide alarm, and never fix a stove to a panel by backfeeding; use a plug-in cord or a properly installed inlet, interlock or transfer switch, see generator inlet tool.
- A pellet stove is a good fit for a station because the draw is low. If you also need the furnace blower, see gas furnace blower on a power station; a space heater is a much bigger load, see space heater.
Open the calculator with a pellet stove filled in
Appliance figures are typical values, not measurements of your device: the label or a plug-in watt meter on yours wins. The sums assume 85% of a battery's rated capacity reaches your outlets (how the numbers work). We list no prices and have not hands-on tested any product.