Can a power station run a washing machine?
Yes, a typical washer runs fine on a power station of 1 kWh or more, as long as the station's output rating covers the motor's start-up surge. Most of the energy in a hot wash goes to heating water, so a cold wash uses far less.
Typical numbers
| Item | Typical running | Typical start-up surge | Energy per load |
|---|---|---|---|
| Washing machine (one cycle) | about 500 W | about 1,500 W | about 500 Wh |
Typical values for a standard cold or warm wash of about one hour. Hot-water cycles, heavy loads and washers with internal water heaters draw more; a high-efficiency front loader on cold can use well under half of this. Check the label or use a plug-in watt meter on yours.
Worked example
500 W × 1 hour = 500 Wh per load. With 85% of rated capacity usable:
| Battery rating | Usable | Full loads of laundry |
|---|---|---|
| 1,000 Wh | 850 Wh | 1 |
| 2,000 Wh | 1,700 Wh | 3 |
| 3,000 Wh | 2,550 Wh | 5 |
Good to know
- Check the station's continuous and surge ratings: the motor needs about 1,500 W for a moment when it starts. A station rated under that may shut down on overload. The soft-start and surge check covers this.
- Wash on cold to save most of the energy. Washers with a built-in heater, and electric dryers, are a different story: a dryer draws thousands of watts and is not a job for a small station.
- Washers need running water. If you are on a well pump, add its load to the sum.
- Plug the washer straight into the station rather than through a long extension cord, and keep the station dry and away from the machine's drain.
Open the calculator with a washing machine filled in
Appliance figures are typical values, not measurements of your device: the label or a plug-in watt meter on yours wins. The sums assume 85% of a battery's rated capacity reaches your outlets (how the numbers work). We list no prices and have not hands-on tested any product.
Back to the calculator · Fridge · Well pump · Lights, phones and TV